Fast installation method of LED fluorescent tube
LED fluorescent lamps are widely used, and there are many different installation methods. The advancement of technology leads to the simplification of installation methods, which can be roughly divided into three types
The first inductive ballast
During traditional refitting, the starter s on the light tube support shall be removed, and the two wires of the inductive ballast in the support shall be short circuited and wrapped with electrical insulating tape. After checking that the wire connection is accurate, the decoration mask can be installed, and the appropriate LED fluorescent lamp device can be powered on and lit on this fluorescent tube support. Simply remove the starter. But you should buy LED tubes with voltage withstand of 305V.
The second electronic ballast
Remove all wires on the electronic ballast terminal in the support, connect "L" at the power input end of the support to the lamp holder, and "n" at the power input end of the support to the lamp holder at the other end. Finally, wrap them separately with electrical insulating tape. In order to prevent the refitted light pipe support from mistakenly installing the general fluorescent lamp, a label shall be pasted in a significant direction inside the support, indicating that "this lamp basin is only applicable to the LED fluorescent lamp". After checking that the wire connection is accurate, the decoration mask can be installed, and the appropriate LED fluorescent lamp device can be powered on and lit on this fluorescent tube support.
The third type is inductive ballast and electronic ballast
Using compatible LED fluorescent lamps, we all know that it is a trend for LED lamps to replace traditional fluorescent lamps. However, to replace the LED lamp, the ballast of the original fluorescent lamp needs to be removed and then connected from the beginning. The cost of hiring an electrician in European and American countries is far more than the price of the lamp itself. A LED T8 lamp developed by our company can be used directly by installing the lamp without dismantling the original ballast.
Article from: LED fluorescent tube manufacturer http://mushuren.cn/
-
05-10
LED fluorescent tube manufacturers take you to understand product knowledge
Fluorescent lamp is a straight tube lamp. Traditional fluorescent lamp uses phosphor to emit light, also known as fluorescent tube; Because it is round and tubular, it is also called fluorescent tube
-
03-11
LED fluorescent tube manufacturers tell you the precautions for LED engineering design
When receiving the LED engineering project, according to the customer' s requirements, the site of the project shall be surveyed, and the local pictures of the device shall be taken to provide th
-
02-25
What are the advantages of LED fluorescent tubes
First of all, T8LED fluorescent lamps do not use mercury and do not contain lead. Traditional fluorescent lamps contain a lot of mercury vapor. Once such lamps are broken, the mercury vapor will volat
-
01-18
How to replace the LED fluorescent tube
1. To install a new fluorescent tube, insert the lamp pin into the lamp holder and roll the lamp tube to fix it. If the lamp turns dark, shining or flickering, please replace the lamp. After replaceme